Here are the steps for using the DDX-450 desktop Electric Capper:
1. Equipment Installation
- Place the equipment on a flat and stable workbench and fix it in position.
- Connect the power properly and ensure the grounding wire is reliably connected.
- Check that the drive chain is intact and firmly connected.
2. Equipment Commissioning
- Turn on the power switch and check if the motor and drive are running normally.
- Adjust the capping speed, keep it generally between 200-300 rpm.
- Test run it on no load and ensure the motion is flexible and no abnormal noise.
3. Operation Process
- Align the bottle mouth with the capping head, the capping head will automatically clamp the cap.
- Press the start button, the motor will drive the capping head to rotate and screw the cap onto the bottle mouth.
- Wait until capping is completed, release the bottle mouth and take out the capped bottle.
- Repeat the above steps to complete batch capping operations.
4. Precautions- Select matching capping heads for different bottle sizes.
- Keep the equipment clean to avoid residue on the bottle mouth and cap affecting the capping effect.
- Regularly add lubricating oil to keep the drive chain flexible.
- Stop and repair immediately if any failure occurs.
The above are the basic steps for using the DDX-450 desktop Electric Capper, operate according to the actual situation. Please contact us for technical support if you have any questions during use.